Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
DuraFlex Crown Repair: The Chesapeake Owner’s Guide
DuraFlex crown repair in Chesapeake typically runs $280-$520 installed, depending on flue diameter and whether the chase top needs resealing. We stock DuraFlex-compatible crown components on our trucks and can complete most replacements in a single visit. Most Chesapeake homeowners discover the problem during the first cold snap, when water that seeped through a cracked crown all summer finally freezes and expands, or when they notice rust stains weeping down the chase from a galvanized top that’s eaten through.
Which DuraFlex Models This Applies To
DuraFlex crowns and chase covers span several product lines, and getting the match wrong means a leak you won’t find until the damage is done. The DuraFlex SW (smooth wall) and DW (double wall) stainless liner systems use distinct crown termination specs - the SW line typically terminates with a 13-by-13-inch or 13-by-18-inch crown plate in 5.5-inch or 6-inch diameters, while DW systems require the wider offset collar that clears the air-insulated jacket. The tell is the stamped spec label on the existing crown’s underside, visible from the cleanout or with a quick camera look.
We’re not affiliated with DuraFlex - we’re an independent service provider - which means we source both OEM DuraFlex termination components and quality equivalents from Olympia Chimney and Copperfield when the original spec has been superseded. The aftermarket crowns we use match 304-grade stainless and the same mill-thickness, but we’ll tell you which we’re installing before we order. One gotcha in Chesapeake’s older Great Bridge and South Norfolk homes: original DuraFlex installs from the 1990s often used a 6-inch plate on what’s actually a 5.5-inch liner, with the gap caulked. That caulk fails in Virginia’s humidity cycles. We measure the liner O.D. with a caliper, not a guess, because a 5.5-inch crown forced onto a 6-inch pipe cracks inside two seasons.
Signs Your DuraFlex Crown Repair Is Failing
- Rust streaks down the chase siding. The galvanized steel crown plate is sacrificial - it rusts so the liner doesn’t - but once the coating is breached, Chesapeake’s salt-air proximity from the Elizabeth River accelerates the eat-through. We see this most on east-facing chases that catch morning dew.
- Water in the firebox after hard rain. A cracked or poorly sealed crown lets water track down the flue’s exterior, pooling at the smoke shelf or damper. If you’re mopping the hearth in March, the crown failed last August and you just didn’t know.
- Spalling brick or deteriorated mortar at the chase top. Water entering through a compromised crown freezes overnight during Chesapeake’s January cold snaps, expanding 9 percent and popping the face off bricks. By the time you see this, the crown isn’t the only repair needed.
- Strong downdraft odors even when the fireplace isn’t in use. A crown that no longer seats properly creates negative pressure at the termination, pulling sewer gas or attic air down the flue. The DuraFlex collar gasket hardens flat after about 12-15 Virginia summers; once compressed, it doesn’t rebound.
- Visible gaps or daylight around the liner where it exits the crown. This is past-the-point failure. The crown’s central collar has separated from the plate, or the storm collar above has slipped. Either way, every rain event is pouring directly into your chase cavity.
Replacement Cost & What’s Included
| Component | Price Range |
|---|---|
| DuraFlex-compatible crown plate (5.5″ or 6″) | $85 - $140 |
| Storm collar and silicone seal | $35 - $55 |
| Labor: remove, measure, install, seal | $160 - $325 |
| Chase top resealing (if needed) | $75 - $125 |
| Typical total installed | $280 - $520 |
The spread depends on three things: liner diameter, whether we need to fabricate a custom collar offset for an non-standard chase pitch, and if the existing storm collar has rust-welded itself to the liner and needs cutting. We price it upfront - the number on the estimate is the number on the invoice. Every crown repair carries our 90-Day Done Right Promise in writing. If water gets past our work, we come back. No paperwork to dig up, no arguing.
DIY or Call Us?
A homeowner can safely check the crown from the ground with binoculars for rust, gaps, or missing fasteners. You can also verify water in the firebox after rain - that’s diagnostic, not dangerous. Where DIY goes wrong is the ladder work. Chesapeake’s two-story chases with 10/12 roof pitches put you at height with nothing solid to tie off to, and the crown itself requires breaking a silicone seal that’s often harder than the metal. We’ve had calls where the owner got the old crown off, discovered the liner collar was rotted too, and now had an open flue with rain forecast. We’re happy to finish what you started, but the $89 Seasonal Tune-Up is cheaper than the emergency call. For the repair itself: we bring the right crown, the right sealant rated to 400 degrees continuous, and the camera to confirm the liner interior didn’t take water damage while the crown was failing. Call (757) 590-6579 and we’ll talk through what you’re seeing.
FAQs
A properly installed stainless crown with quality sealant lasts 15-20 years in Chesapeake’s climate, but the storm collar silicone typically needs refresh at year 8-10. The salt air from the river and the thermal cycling of Virginia’s humid summers to freezing winters are harder on seals than the metal itself. Call (757) 590-6579 for an exact quote - estimates are free.
Surface rust on a galvanized crown can be treated and coated as a short-term patch, but once the plate is perforated or the collar seam has opened, replacement is the only sound repair. We’ve tried the patch route on budget requests; the callback rate isn’t worth it to us or the homeowner. Call (757) 590-6579 for an exact quote - estimates are free.
Most DuraFlex crown replacements take 90 minutes to two hours from ladder set to final seal, assuming the liner collar beneath is sound. If the collar needs replacement too, add an hour. Our technicians carry both crown sizes and collar adapters on the truck. Call (757) 590-6579 for an exact quote - estimates are free.
We stock DuraFlex-compatible 5.5-inch and 6-inch stainless crown plates, storm collars, and high-temp silicone on every service vehicle, plus Olympia Chimney and Copperfield equivalents when the original spec has changed. If your system uses a discontinued DuraFlex termination, we’ll know before we leave the ground. Call (757) 590-6579 for an exact quote - estimates are free.
If the chimney’s right, you won’t hear from me until next season. That’s the point.
We’re Hearthstone Chimney Co. - over 42 years in this trade, live person on the phone 24 hours a day, and a 90-Day Done Right Promise that means what it says. Russell Haines and our crew work throughout Chesapeake, from the older brick homes in Great Bridge to the newer builds off Battlefield Boulevard. Photos you can see, a plain-English verdict, and a square deal with no surprises on the bill.
Written by Russell Haines, Owner, Hearthstone Chimney Co. at Hearthstone Chimney Co., serving Chesapeake and nearby areas.





Before
After
Before
After
Before
After